Common Hörmann Garage Door Faults and Fixes
Share
What Are the Most Common Hörmann Garage Door Faults?
Most Hörmann garage door faults follow predictable patterns and can be diagnosed from the symptoms. This guide covers the most common faults on Hörmann canopy, retractable and sectional doors, with the cause and correct fix for each
Common fault diagnosis guide
| Symptom | Most likely cause | Fix |
|---|---|---|
| Door very heavy to lift manually | Broken or weakened spring | Replace spring. On retractable doors, replace both spring clusters. On canopy doors, replace the overhead spring assembly. |
| Door drops or sags on one side when opening | Frayed or snapped lift cable | Replace both lift cables and inspect cones for wear. |
| Grinding or scraping noise when door moves | Worn or seized roller spindles | Replace roller spindle assemblies. Inspect track for debris or damage. |
| Remote stops working | Battery flat; lost pairing; faulty receiver | Replace battery first. If still not working, reprogram the remote. If reprogramming fails, check receiver module. |
| Door does not latch when closed | Worn latch assembly or keeper | Replace latch assembly and/or keeper. Check lock rod length and adjustment. |
| Handle turns but door does not lock | Broken cam in lock body; disconnected lock rod | Replace lock mechanism body. Check lock rod connections at each end. |
| Door bounces back up when closing (motorised) | Obstacle detection triggered; limit switch setting | Check for obstruction in door path. If clear, adjust travel limits on motor unit. Check safety edge seals. |
| Motor runs but door does not move | Disconnected towing arm; failed drive mechanism | Check towing arm connection to door. Check drive belt or chain for failure. |
| Door off track on one side | Roller out of track; bent track | Carefully guide roller back into track. If track is bent, straighten or replace the affected section. |
| Door stiff in cold weather | Seized spindles or lubrication failure | Lubricate all moving parts with a silicone or PTFE spray. Replace seized spindles. |
Maintenance to prevent common faults
Most Hörmann door faults develop gradually and can be caught early with basic annual maintenance. A maintenance check takes around 15 minutes and covers:
- Lubricate all roller spindles, the spring shaft bushes, hinge pivot points and lock mechanism with a silicone or PTFE-based spray. Do not use WD-40 as it attracts dirt and dries out quickly.
- Check cables for fraying or kinking along their full length on both sides of the door.
- Check that the door balances correctly when opened halfway and released: a correctly tensioned door should stay in position without moving up or down.
- Test the remote from the furthest practical distance. Reduced range often precedes a complete pairing failure.
- Check the latch operation by manually operating the lock handle and confirming that the latches at the top or bottom of the door engage and disengage cleanly.
The balance test is the single most useful annual check. Open the door to approximately halfway and release it. If the door rises, the spring tension is too high. If it drops, the spring is weakening. A correctly balanced door stays stationary at the halfway position. A door that will not balance at all has likely lost one or both springs and needs immediate attention.
Browse all Hörmann replacement parts at Northwest Garage Door Spares, with genuine and pattern parts for all common Hörmann door types.
Hörmann Garage Door Spares
Genuine and pattern replacement parts for all Hörmann garage door types. Fast UK delivery.
More Hörmann guides on remotes, springs, locks, cables and common faults in the Hörmann Spares hub.
Visit the Hub
For more Hörmann garage door guides, visit the Hörmann Spares Guides hub.